Відео

Good explanations

just supreb. very nicely explained.

Is it the explanation rules for amperes for DC motors or AC motors? I think there is difference. (It is not my video to talk).

Why the subtitles is shown this way .. not able to see the video peoperly

those pilz relay are the worst, always defected and expensive to replace, after a shutdown of equipment they get faulty you need to keep taking out bottom connector and insert to restart it

What ifusing one timer in the side of the grid

This is very educational and one of the best videos that really explained this topic

Cap should be on the RUN winding, not the start winding.

Hi sir good evening very nice your circuit and explanation 👍 Thanks 🙏 Please upload single phase supply to three phase vrd circuit how to make

Subtitles hide the animation.

This is very clear, thanks

Yes I really like your design

very good

Good work but quality of the video is too poor.

Very useful information thank you lot team🎉

3 input ats explain ua-cam.com/video/dBVfle-HhRg/v-deo.html

Insightful and educative ❤

Only if the motor itself is running.

Tuyệt vời

Thanks for the informative video. What size fuses (normal or air?) do you recommend to place before the SPD? I have 16A 4P 230V coming in from the grid and 63A 2P 230V from local solar inverter.

Why do we need a Master Relay before the Magnetic contactor?

❤it’s awesome ur expelling thanks

best videos for explaining the core concept of inverter, thank you so much 🙏🙏

Does anybody know why the timer is set to 5sec here?

Best ATS panel connection

Nice!, can you explain how to connect two synchro generators?

Hi sir we have a 400V 3 phase generator with ATS, the time delay when a power supply is off is 30-35 secs. Is that okay?

But how does 1.5kv is safer for the server?

The general basis of wiring an emergency stop button for a non-intelligent equipment is to use the N/C contact as a main switch of the whole control circuit. Multiple E-stops should be wired in series so they operate in NOR logic - One button pushed, control power interrupted, all relays released, all motors de-energized. For some intelligent equipments with PLC's, things can be different. It's possible that some E-stop buttons are included in a detection loop of the safety relay, which cuts off power to actuators and tells PLC to pause its work, pop up a trouble code and not to resume unless an extra manual resetting signal is received (by pressing "Trouble Reset" or even entering an admin password)

Any reasons why my egs002 led blinks??

Je vous donne courage

Amazing 👏🏾

Finally I understood pwm now.Thanks sir🫂

I have benefited, thanks. I also like the you explaining, clear and to the point

Excellent 👍

excellent sir

excellent sir

excellent sir

Thanks 👍👍👍

Thanks 👍👍👍👍👍👍👍👍👍

so lovely

Hallo..can you request ATS with COS MOTORIZED..? by I like this is you channel..

Thank you so much for you'r explanation. That was quite helpful to understand the procedure.

❤

the bad way to explain ! in electricity we use schematic diagram for wiring devices . relay ; contactor etc are not the same in all marc

thank you

Hello! Please! Would someone explain me how can the voltage be synchronized with current on principal coil? The coil reactance doesn't make current be late compared to the voltage? Thanks...

Good. Thank you

what if you added manual control using a selector switch and 4 push buttons